Preparation for the site: Before applying Puttelite, for the new wall, use 120 sandpaper or stone, and for the old wall, use a scraper or soap to clean up the wall. New plaster is needed to cover different flaws, holes, and cracks in the wall. Use Puttelite to plain only for small holes, cracks, or flaws.
 
Step 1: Use 1 coat of Aclose Sealer (water-based) for new walls and then dry it for 3 - 5 hours. For old walls use 1 coat Plastelite Wall Sealer (solvent-based) and dry it for 18 - 24 hours. If there is a chance of salt dampness, then a salt seal can be used as an undercoat.
 
Step 2: For covering different flaws, holes, cracks and smoothing the wall, use Puttelite Wall Putty. It will take 3 - 5 hours to get the wall dried up. After that, smoothen the wall by using 180 sandpaper. Use 1 coat of Puttelite again to smoothen the wall completely after finding out the flaw and unequal space by using light. Give again 3-5 hours for drying up. After that, smoothen the wall by using 220 sandpaper.
 
Step 3: Apply 1 coat of Aclose Sealer. After that, smoothen the wall by using 320 sandpaper. And finally use the top coat.
 
Special Note: Puttelite is sent to the market directly as ready paint in the package, so it is not necessary to use water or chalk powder with this. Per kg, coverage is about 80 – 90 sqft as 1 coat. Use a putty knife or scrapper to apply Puttelite. Tightly close the lid after every use so that air does not harm the paint.